Ice Level Controls - Scotsman HID312 Manual De Uso

HID312 and HID525 50 Hz
Installation and User's Manual

Ice level controls

Clean if the controller indicates bin full and there
is no ice between the sensors.
1. Remove top front and top panels.
2. Shut machine off.
3. Disconnect ice level controls at connector.
4. Remove 3 screws and ice storage bin cover.
5. Pull each sensor grommet clip up and off.
Cover
Sensor
6. Push grommets out of bin top.
7. Pull each sensor out of its rubber grommet. Pull
on the part closest to the grommet, not the wire.
8. Wipe the sensor lenses clean with a soft, clean
cloth. Caution - do not scratch the lens. If there
is mineral scale on the lens, ice machine scale
remover will be needed to wipe them clean.
9. Return each sensor to a grommet, push it in until it
snaps into place.
10. Reverse the rest of the steps to reassemble.
Dispensing Bin
The dispensing bin may be removed for cleaning or to
provide service access to other components.
1. Go thru steps 1 thru 10 of the Bin Cleaning
Procedure above.
2. Remove ice sweep.
3. Remove ice delivery chute and chute cover.
4. Twist and remove the water and ice dispense
chutes.
Clip
Grommet
5. Remove the chute
mounting panel.
6. Remove splash
panel, disconnect
sensors from
harness and set
panel aside.
7. Locate two 3
prong knob bolts
under the bin.
Remove them.
8. Locate bin drain
and disconnect it
from bin fitting.
9. Lift the bin up and
off the chassis.
Clean as needed.
April 2015
Page 15