Other Maintenance - Scotsman HID312 Manual De Uso

HID312 and HID525 50 Hz
Installation and User's Manual

Other Maintenance

Note: Cleaning and maintenance must not be done by
children without supervision.
Remove the build up of mineral scale from the ice
machine's water system and sensors.
Sanitize the ice machine's water system and the ice
storage bin or dispenser.
Clean or replace the air filter and clean the air cooled
condenser (air cooled models only).
It is the User's responsibility to keep the ice machine
and ice storage bin in a sanitary condition.
Sanitize the ice storage bin as frequently as local
health codes require, and every time the ice machine
is cleaned and sanitized.
The ice machine's water system should be cleaned
and sanitized a minimum of twice per year. This is
critical to the proper operation of the ice machine.
Contact your local authorized service agent for water
system cleaning.
The auger in the ice making system is centered by
bearings at the top and bottom. It is also sealed from
Bearing
leaking by a water seal at the bottom.
The bearings are permanently lubricated and need
no maintenance. The can be visually checked for
obvious wear or damage but there is no need to add
lubrication.
Auger motor bearings and the gear reducer are also
permanently lubricated and need no maintenance.
The bottom of the ice making system should be
checked for water leaks. Water draining from
the bottom is an indication of a water seal leak.
Immediate repair is required when a water seal leak is
discovered.
Caution: Moving parts hazard. Do not touch the
rotating shaft at any time.
Rotating Shaft -
Do NOT Touch
April 2015
Page 16