Bosch Zamo Manual Original página 33

Operation
Switching the laser measure on/off
– To switch on the measuring tool, briefly press the measur-
ing button (1). When the measuring tool is switched on, the
laser beam is switched on. The indicator flashes on the
display.
– To switch off the measuring tool, hold down the measuring
button (1).
Measuring process
A continuous measurement is performed after the measuring
tool has been switched on. The current measured value (g) is
shown on the bottom line of the display (see figure A). During
continuous measurement, the measuring tool can be moved
relative to the target and the current measured value (g) will
be updated approx. every 0.5 seconds on the bottom line of
the display (see figure B). The indicator flashes on the dis-
play.
The rear edge of the measuring tool is the reference level for
the measurement ( ). (See figure C)
Measuring length
– Press the measuring button (1) to stop the measuring pro-
cess. The laser beam is switched off and the current meas-
ured value (g) is displayed.
– Press the measuring button (1) again to switch the laser
back on and continue measuring. The current measured
value (g) is shown on the bottom line of the display, while
the previous measured value (e) is displayed above it.
Area measurement
– Press the measuring button (1) twice in quick succession to
multiply the last two measurements together (see figure D).
The indicator
urement is shown.
Bosch Power Tools
appears on the display and the area meas-
1 609 92A 454 | (14.06.2018)
English | 33