Maintenance And Servicing; Maintenance And Cleaning - Bosch Zamo Manual Original

again.
The current measured value (g) is updated on the bottom
line of the display.
– The measuring process ends once the wheel has come to a
stop. The current measured value (g) is shown.
– Press the measuring button (1) again to save the measured
value, and continue measuring. The current measured value
(g) is shown on the bottom line of the display, while the
previous measured value (e) is displayed above it.
Note: In order to obtain an exact measurement, do not change
the angle between the measuring tool and the surface (see fig-
ure L). Make sure that you apply a steady amount of pressure
throughout the measuring process. The result may vary on soft
substrates and/or when applying excessive pressure. The re-
commended pressure for an exact measurement result is 500
g.
Area measurement
– Press the measuring button (1) twice in quick succession to
multiply the last two measurements together. The indicator
appears on the display and the area measurement is
shown.

Maintenance and Servicing

Maintenance and cleaning

Keep the measuring tool clean at all times.
Never immerse the measuring tool in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any de-
tergents or solvents.
Take particular care of the reception lens (7), which must be
handled with the same level of care you would give to a pair of
glasses or a camera lens.
Bosch Power Tools
English | 39
1 609 92A 454 | (14.06.2018)