18.0 Hip Pad Adjustment
Hip Pad Width
•
Un-tighten allen key bolt (A) by a half turn using the 4mm
allen key supplied. Then slide the hip pad along the hip pad
bar (B) to set at the desired width.
•
Re-tighten the allen key bolt (A) to secure the pad in place.
Fig.17.1
B
18
19.0 Pommel Adjustment
Adjusting Pommel Height
NOTE: The height adjustment can be used for removing the
pommel or adjusting accordingly to the height of the chair
cushion.
•
•
•
Fore and Aft Adjustment
Un-tighten allen key bolt (C) and move the pommel along the
slot in the metal pommel bracket.
A
Re-tighten bolt (C) to secure in place.
NOTE: You can get additional fore and aft adjustment by
removing the fixing screw (C) altogether then dismounting the
pad from the metalwork, rotating the metalwork 180°, re-fixing
the pad and replacing the bolt (C), tightening in place.
Pull and hold out plunger (A) whilst moving the pommel up
or down to achieve the desired height.
Release plunger (A) relocating it into one of the holes (B) in
the pommel bar. Always ensure the plungers are locked
securely in place, before use.
The pommel can also be removed this way.
Fig.18.1
A
B
Fig.18.2
C
Neptune Rev.1.0