Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
16.0 Lateral Support Adjustments
WARNING!
•
Check that the supports are not too high under the arms of
the user or tight around chest area by running your fingers
around the inside of the supports.
•
Check that the supports do not infringe on any feeding
tubes.
Height & Width of Supports,
•
Loosen both bolts (A) by half a turn using the 4mm allen
key provided.
•
Slide the pads up or down along the slot in the seat back
(B) to adjust the height, and outwards to set the width and /
or angle.
•
Re-tighten the allen key bolts to secure the supports in
place.
NOTE: Flip away laterals are available as an upgrade if access
for hoisting is required.
Fig.16.1
B
17.0 Head Rest - Adjustment
WARNING!
Always check that the headrest is secure and the wings are not
tight around the head. The headrest wings are ideally set at 45
degrees to the back.
Adjusting the Wing Angle
Adjustment point (A) allows you to move the wing position to
offer more side support to the head, (Fig.16.2).
•
Unzip the headrest cover at the back and loosen the allen
key bolts (A) using the 4mm allen key provided.
•
Adjust the sides of the headrest into the desired position.
•
After desired position has been reached tighten the bolts to
secure in place.
Neptune Rev.1.0
(Fig.16.1)
A
NOTE: Perform this for either side wing of the headrest.
Adjusting the Headrest Angle
•
Adjustment points (B) allow you to alter the angle of the
headrest to support the head and neck.
•
Levers (B) should be operated together to achieve the
desired head positioning of the user. Loosen the levers by
turning anti-clockwise.
•
Once loose, the head support angle can be manually
adjusted to suit the user.
•
Tighten the levers to secure in place.
Adjusting the Headrest Height
•
Loosen the hand wheel (C)
•
Slide the headrest up or down inside the bracket on the
back of the chair.
•
Re tighten the hand wheel to secure in place.
Fig.16.2
Fig.16.3
B
C
A
17
Publicidad
Capítulos
Tabla de contenido
