Back Angle Adjustment - Quickie Q7 Manual De Instrucciones

E NG LIS H
S. BACK ANGLE ADJUSTMENT
Folding and Unfolding Backrest
1. Release the backrest by pulling the release cord (A) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to the desired angle or to
the folded down position.
3. Lock the backrest in place by releasing the cord and allowing the pins (B) to engage in the
nearest hole (D) of the backrest bracket (C).
CAUTION– Be sure the pins (B) are fully engaged through the backrest bracket (C) on both sides of the chair.
Test the backrest to be sure it is locked before use.
CAUTION – When changing the back angle of the wheelchair both the left and right angle adjustable back
bracket must be in the same hole position before the wheelchair is to be used.
Adjusting Backrest Options
Backrest bracket has two positions, Forward Mount and Rearwad Mount. Change the bracket position
by removing bolt (E) and pivoting the bracket forward or rearward. Reinsert the bolt in the new posi-
tion and tighten. Then follow the instructions for "Folding and Unfolding backrest".
F= Forward Mount R= Rearward Mount
Backrest Angle Preset Plugs
The preset plugs allow you to unemploy the backrest bracket holes you do not wish to use. This
allows the backrest to automatically lock into your desired angle position after unfolding.
1. Determine which backrest bracket holes you do not want to use.
2. Insert plugs (F) into the predetermined holes from the chair side of the bracket (G).
3. To ensure the backrest will lock in the folded position, do not insert a plug into the lowest
hole position (G).
63 64 65
63 64
65
66
27
63
64
65
Forward
E
Rearward
E
66
F
G
112786 Rev. F