About This Documentation - Aventics CR1-OX Instrucciones De Servicio

AVENTICS | CR1-OX | R414010019–BAL–001–AA | English
English
1

About this Documentation

These instructions contain important information
for the safe and appropriate assembly and commissioning
of the product.
O Read these instructions carefully, especially chapter
"Notes on safety", before you start working with
the product.
Additional documentation
O Also follow the instructions for the other system
components.
O Please also observe the generally relevant, statutory
and other binding regulations of European and national
legislation and the national regulations for accident
prevention and environmental protection in your
country.
Presentation of information
Warnings
In this document, there are safety instructions before the
steps whenever there is a danger of personal injury or
damage to the equipment. The measures described to
avoid these hazards must be followed.
Structure of warnings
Hazard type and source
Consequences of non-observance
O Measures to avoid these hazards
Meaning of the signal words
Indicates a hazardous situation which, if not avoided,
will certainly result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injuries.
Indicates that damage may be inflicted on the product
or the environment.
SIGNAL WORD
DANGER
WARNING
CAUTION
NOTICE
Symbols
Operation may be impaired if this information is
disregarded.
2 Notes on safety
The product has been manufactured according to the
accepted rules of current technology. Even so, there is
a risk of injury or damage if the following general safety
instructions and the specific warnings given in this
instruction manual are not observed.
O Please read all these instructions carefully before
working with the product.
O Keep these instructions in a location where they
are accessible to all users at all times.
O Always include the operating instructions when
you pass the product onto third parties.
Intended use
The product is exclusively intended for installation in
a machine or system or for combination with other
components to form a machine or system. The product
may only be commissioned after it has been installed in
the machine/system for which it is intended.
Use is permitted only under the operating conditions and
within the performance limits listed in the technical data.
Only use oxygen, air, or inert gas as the medium.
The product is technical equipment and is intended for
professional use only.
Intended use includes having read and understood these
instructions, especially chapter "Notes on safety".
Personnel qualifications
All tasks associated with the product require basic
mechanical, pneumatic and electrical knowledge, as well
as knowledge of the respective technical terms. In order to
ensure operational safety, these tasks may only be carried
out by qualified personnel or an instructed person under
the direction of qualified personnel.
Qualified personnel are those who can recognize possible
hazards and institute the appropriate safety measures,
due to their professional training, knowledge, and
experience, as well as their understanding of the relevant
regulations pertaining to the work to be done.
Qualified personnel must observe the rules relevant to the
subject area.
4