Using Latch; Using A Lap And Shoulder Belt - CYBEX gold CLOUD Q Manual Del Propietário

INSTALLING THE BASE USING LATCH
8. Press the Belt Tensioning Plate down with both
hands, where indicated, until it locks into place. The
orange Locking Lever will rotate to the CLOSE
position automatically when the Plate is locked.
If Belt Tensioning Plate does not lock, try loosening the LATCH strap
slightly.
9. Grab the Base at the Belt Guides and pull from side to side
and front to back to make sure it is installed correctly. The base
should not move more than 1 inch (2.5 cm) in any direction.
If the Base moves too much, open the Belt Tensioning Plate, tension
the LATCH Strap a little more and try again. After this, if the Base still
moves too much, you may need to try a different vehicle seat location
or installation method, or both.
10. Squeeze the Adjustment Handle on the Load Leg
and extend it until the Foot makes firm contact with
vehicle floor. Lock Leg into place using the first hole
that will firmly lock it against the vehicle floor.
It may be necessary to lift up slightly on the Base to allow the Foot to
lock into the hole. See page 30.
11. Check that the Recline Angle remained in the appropriate
range for the child's weight. If not, remove Base,
adjust recline angle and reinstall. See page 31.
33
Automatic
8
DO NOT turn
9
10
11
Use the FIRST hole
that will lock the Load
Leg Foot firmly against
vehicle floor
INSTALLING THE BASE USING A LAP AND SHOULDER BELT
1. Unfold the Load Leg from underneath the Base.
2. Position Base on a rear vehicle seat. If a hump is present
on the floor of the vehicle, See page 30 for important
information on using the Load Leg in this seating position.
3. Adjust the Leveling Foot to achieve the correct range for your
child's weight as shown on the Level Indicator. See page 31.
4. Fully open Belt Tensioning Plate by turning the orange Locking
Lever to the OPEN position and lifting up on the Plate.
Once open, the Belt Tensioning Plate will remain open on its own. The
Locking Lever should be in the OPEN position with the Plate open.
5. Pull out vehicle belt to form a single length of about 24
inches (60 cm). Hold the buckle Tongue in one hand and
squeeze the lap and shoulder belts together in the other.
6. Route the vehicle belts under the Belt Tensioning
Plate, and through the Blue Belt Guides on both
sides of the Base. BUCKLE THE BELT. Make
sure the belts lay flat and are not twisted.
The vehicle belt should ALWAYS be routed UNDER the tab on the Belt
Guide. NEVER place a vehicle belt over the tab on the Belt Guide, even
in a vehicle with longer buckle stalks.
7. On the buckle side, first lift up on the shoulder belt to
a
remove slack in the lap belt . Then remove slack
b
from the shoulder belt on the opposite side .
At this point, only remove slack from the vehicle belts, being careful
not to over tighten them. The Belt Tensioning Plate will tighten the
system fully. If you have previously installed the seat using LATCH,
make sure the LATCH Strap lies flat on the bottom of the Base. See
"To Store" section on page 29.
2
3
1
4
5
24 inches
60 cm
6
7
a
b
34