CYBEX gold CLOUD Q Manual Del Propietário página 29

USING SENSORSAFE
1. INSTALL THE SENSORSAFE
Locate the 16PIN OBDII port a in your vehicle. Refer to your vehicle owner's manual for
location. Plug in the SensorSafe Receiver.
If unable to locate your vehicle manual, the SensorSafe
Application may contain information regarding the location of the
16PIN OBDII port for your vehicle.
Your SensorSafe
communicates with the vehicle network. In some vehicles this
a
occurs immediately after installing the SensorSafe
In other vehicles the tone will not be heard until the vehicle has
been started.
This initialization signal only occurs one time after installation.
2. POWER UP THE VEHICLE.
55
™
RECEIVER.
™
Receiver will sound when it first
™
™
3. CYCLE THE SENSORSAFE
Your SensorSafe
fastened for more than 12 hours. To reset, or "wake up" the Chest
Clip, unfasten then re-fasten it. When you do this, the blue LED will
flash two times. TO PRESERVE BATTERY LIFE, ALWAYS STORE
™
THE SENSORSAFE CHEST CLIP IN THE UNCLIPPED POSITION.
4. DRIVE THE VEHICLE.
The SensorSafe Receiver is designed to respond after the vehicle has been driven at 5 miles per
hour or more.
Receiver.
5. PARK THE VEHICLE AND TURN OFF THE IGNITION.
Within 2 seconds of parking your vehicle and turning off the ignition you will hear the SensorSafe
reminder, alerting you that your baby is in the vehicle. If you don't hear the reminder tone, test your
SensorSafe by following steps 1-5 again. Contact CYBEX at: 1-877-242-5676 or online at:
™
http://cybex-online.com/us/contact.html
NOTE: SensorSafe Receiver will also alarm if your child unclips the Chest Clip after the
vehicle has been driven at 5 miles per hour or more, but only if the vehicle is on.
USING SENSORSAFE
CHEST CLIP.
™
Chest Clip is designed to "go to sleep" if left
™
if the reminder tone again fails to sound.
™
™
56