Care And Cleaning; Removing The Seat Cover; Washing Instructions - CYBEX gold CLOUD Q Manual Del Propietário

CARE AND CLEANING

REMOVING THE SEAT COVER

The integrated Harness System cannot be removed
from the seat. NEVER remove or attempt to remove
parts of the Harness System.
DO NOT damage, remove or dispose of any EPS foam.
NEVER use Infant Carrier without a properly installed
Seat Cover.
To remove please follow these steps:
1. Undo the belt buckle.
2. Unsnap the two Shoulder Pads from the harness.
3. If using the Infant Insert, simply unsnap the two
snaps holding it around the harness straps.
4. Pull the Headrest Cover over the edge.
5. Unsnap the two snaps connecting to the Backrest Cover.
6. Unsnap the two snaps creating the harness slot.
7. Unsnap the two black snaps holding the canopy
fabric and push canopy forward.
8. Unsnap the three gray snaps from the top of the plastic shell.
9. Unsnap two silver dual action snaps- same as for canopy straps.
10. Unthread fabric around European Belt Buckle
and LSP devices, then pull up over the top.
11. Pull forward and over the side wings, unsnap 2
gray snaps and 2 silver snaps connecting to Leg
Support Cover, as well as 2 gray snaps connecting
to plastic shell and remove the Backrest Cover.
12. Fully recline seat, unsnap opening for hip belt
and lift fabric over the side. Finally thread Crotch
Buckle through the Crotch Buckle Pad.
47
INSTALLING THE SEAT COVER
Reverse the removal instructions to reinstall the Seat Cover.
BACKREST COVER
SHOULDER PADS
HEADREST COVER LEG SUPPORT COVER
CARE AND CLEANING
SPOT CLEANING
Spot clean Seat Covers, Shoulder Pads, Buckle Pad, and the
Infant Insert as needed with a clean cloth using mild detergent and
water.

WASHING INSTRUCTIONS

Seat cover parts can be washed as follows:
• Preferably wash by hand in lukewarm water
• Machine wash COLD, gentle cycle, mild detergent
• Line Dry
DO NOT (or cover will shrink)
• Do NOT machine wash warm or hot
• DO NOT TUMBLE DRY
• Do NOT iron
• Do NOT use bleach
NEVER remove Harness or Harness components from
Infant Carrier.
NEVER use bleach, household cleaners or solvents.
DO NOT lubricate.
HARNESS STRAPS
Sponge clean using warm water and mild soap. Air dry. Do not iron.
HARNESS BUCKLE
Sponge clean or thoroughly rinse Harness Buckle with warm water.
Allow to dry thoroughly. Test by fastening and unfastening until an
audible CLICK is heard after inserting each Buckle Tongue into the
Buckle. If CLICKS are not heard, repeat the cleaning procedure.
LATCH CONNECTORS
Sponge clean or thoroughly rinse LATCH Connectors with
warm water. Allow to dry thoroughly. Test by connecting and
disconnecting until an audible CLICK is heard after connecting
each connector to a lower LATCH anchor. If clicks are not heard,
repeat the cleaning procedure.
PLASTIC PARTS
Wipe clean with mild detergent and warm water.
48