Flash Exposure Compensation; Setting Procedure - Leica SF 64 Manual De Instrucciónes, Uso Y Manutención

EN

FLASH EXPOSURE COMPENSATION

The automatic flash exposure of most cameras is
harmonized to a reflection factor of 25% (average
reflection factor of flash shots).
A dark subject that absorbs a lot of light or a bright or
strongly reflective subject, or a main subject that is
much darker than its surroundings (e.g. back-lit shots)
can result in overexposure or underexposure of the
subject.
To compensate for this effect, the flash exposure can
be adjusted manually with a compensation value in
the
sation value depends on the brightness of the subject
or the contrast between the (main) subject and
picture background!
Compensation values from -3 to +3 aperture values
(EV) can be set in third stages on the flash unit.
Tip:
– Dark subject against a bright picture background:
– Bright subject against a dark picture background:

Setting procedure

1. On the touch display press the sensor button for
2. Use
3. Press selected compensation value
64
and flash modes. The level of the compen-
TTL A
positive compensation value.
negative compensation value.
flash exposure compensation until the
EV
relevant selection list appears
/ to move the desired compensation
▲ ▼
value to the central field outlined in red
The setting takes effect immediately.
Notes:
• Flash exposure compensation in the
modes can only work if the camera supports
setting a compensation value on the flash unit (see
camera manual)!
If not, the compensation value set remains
ineffective.
In some camera types the manual flash exposure
compensation must be set on the camera. No
compensation value is shown in the flash unit
display.
• Exposure compensation by changing the lens
aperture is not possible since the camera's
automatic exposure, in turn, views the changed
aperture as the normal working aperture. When
setting a compensation value the range indicator in
the display can change and the compensation
value displayed (depending on the camera type)/.
• Don't forget to reset a flash exposure compensa-
tion to if you want to take flash shots with normal
0
flash illumination again!
flash
TTL