Drive Display; Location Of Drive - Franklin Electric SubDrive15 Manual De Uso

Drive Display

System Idle
When the SubDrive/MonoDrive unit is powered on and idle (not pumping water), the
display will be illuminated and "- - -" will be shown.
Drive Running
When the SubDrive/MonoDrive unit is controlling the motor and pump, the display will be
illuminated and the frequency of the motor/pump (in Hertz, or cycles per second) will be
shown on the display.
Fault Detected
When a fault condition is detected in the system, the drive display will illuminate red and
the fault code will be displayed. All fault codes begin with "F" and followed by a one- or
two-digit number. Consult the Diagnostic Fault Codes table in the back of this manual for
more information.

Location of Drive

The SubDrive/MonoDrive controller is intended for operation in ambient temperatures from
-13 °F to 122 °F (-25 °C to 50 °C) at 230 VAC input. The following recommendations will
help in selection of the proper location of the controller.
• A tank tee is recommended for mounting the tank, pressure sensor, pressure
gauge, and pressure relief valve at one junction. If a tank tee is not used, the
pressure sensor should be located within 6 feet (1.8 meters) of the pressure tank to
minimize pressure fluctuations. There should be no elbows between the tank and
pressure sensor.
• The unit should be mounted on a sturdy supporting structure such as a wall or
supporting post. Please take into account the weight of the unit.
• The electronics inside the SubDrive/MonoDrive are air-cooled. As a result, there
should be at least 6 inches (15.24 cm) of clearance on each side and below the unit
to allow room for air flow.
• The mounting location should have access to 230 VAC electrical supply and to the
submersible motor wiring. To avoid possible interference with other appliances,
please refer to the Wire Routing section of this manual and observe all precautions
regarding power cable routing.
SubDrive/MonoDrive
13