Installation Procedure; Drive Mounting - Franklin Electric SubDrive15 Manual De Uso

Installation Procedure

Drive Mounting

The SubDrive/MonoDrive unit should be mounted on a surface or backplate no smaller
than the outer controller dimensions in order to maintain the NEMA 3R rating. The controller
must be mounted at least 18" (45.7 cm) off the ground.
"A"
"B"
The controller is mounted using the hanging tab on the top side of the enclosure, as well
as two (2) additional mounting holes on the back side of the controller. All three (3) screw
hole locations should be used to ensure the controller is securely mounted to the backplate
or wall.
250,5
[9.86]
SubDrive/MonoDrive
"C"
"D"
157,4
[6.19]
133,9
[5.27]
25