Declaration Of Conformity; Description; Branch Circuit Protection - Franklin Electric SubDrive15 Manual De Uso

SubDrive/MonoDrive
Model No.
587 020 5003
587 020 5103
587 020 5203
587 020 5303
587 020 5403
NATIONAL SANITATION FOUNDATION INFORMATION
The enclosed stainless steel pressure sensor(s) have been evaluated by
Underwriters Laboratories Inc. and found to comply with the low lead
requirements described in NSF/ANSI 61 - Annex G.
MOTOR OVERLOAD PROTECTION NOTE:
The drive electronics provide motor overload protection by preventing motor current from
exceeding the maximum Service Factor Amps (SFA). Motor overtemperature sensing is not
provided by the drive.

BRANCH CIRCUIT PROTECTION

Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical Code
and any additional local codes, or the equivalent. Drive shall be protected by inverse-time
fuse or Circuit breaker only, rated 300 V, maximum 300% of the full-load motor output
current rating as noted in the Fuse/Circuit Breaker and Wire Sizing section below.
Wi-Fi MODULE
The Wi-Fi module has been tested and found to comply with part 15 of FCC Rules.
These limits are designed to provide reasonable protection against harmful interference.
This equipment generates, uses, and can radiate radio frequency energy for limited
periods (approx. 15 min.) and, if the drive is not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4

Declaration of Conformity

Model Description
A 3Ror/outdoor)
MonoDrive
SubDrive15
MonoDriveXT
SubDrive20
SubDrive30
E184902
UL File: MH18335