Wall-Mounting; Identification Label; Functional Diagram - Carel HumiSonic Manual Del Usuario

ENG

WALL-MOUNTING

2
3
1
AIR
3.7 Wall-mounting
NOTICE:
mount the unit only to a masonry wall.
Fit the humidifier to the wall using the support bracket already fixed to
the humidifier, and the kit of screws supplied (for the dimensions and
weights see the previous paragraph).
Assembly instructions:
• fasten the wall bracket, checking horizontal position with a spirit level.
Drill the holes in the wall using the bracket as a template. If mounting
on a masonry wall, use the plastic anchors (Ø 8 mm, Ø 0.31 in) and
screws (Ø 5 mm x L= 50 mm, Ø 0.19 in x L= 1.97 in) supplied;
• use a wire cutter to remove the knock-outs from the panel trim the
burrs.
CAUTION: risk of injury. Wear personal protective clothing.
• attach the humidifier to the bracket;
Dimensions mm (in) UU02
X 198 (7.8)
Direct version for room applic. +0300062EE - rel. 1.4 - 24.09.2020
2
1 4
AIR
Fig. 3.d
Fig. 3.e
X
Fig. 3.f
UU04 UU06 UU08
323 (12.7) 448 (17.6) 573 (22.5)
• adjust the feet at the rear to make sure the humidifier is parallel to the
floor, using a spirit level.
> 0,45 m
(1.47 ft)
> 2 m
(6.56 ft)
3.8 Identification label
The humidifiers are identifiable from the packaging label and the
identification label accessible after having removed the cover.
NOTICE:
tampering, removal or absence of the identification label or
anything else that does not allow certain identification of the product
will make any installation or maintenance operations difficult.

3.9 Functional diagram

1
2
11
Tab. 3.c
8
> 3,5 m (11.48 ft)
Fig. 3.g
04-Nov-2014
Date
Rev. 2.0
A 0 00 20 66
S.N.
UU02RD0000
Code
Date 04-Nov-2014 20 2 2 14
S.N. UU02RD0000 A 0 00 20 66 6 6 6 Re Rev. 2.0 R R v e e 2 0
Code
Fig. 3.h
4
3
4
3
14
15
6
M
5 5 5 5
9 9
11
10
7
M
8
12
13
Fig. 3.i