Toro V-21S Manual Del Operador página 14

14. Stop the blade when pushing the mower outside
the lawn area.
15. Stop engine before leaving the operator's
position – behind the handle. Disconnect wire
from spark plug if mower will be unattended.
16. Do not touch any engine components while it is
running or shortly after it is stopped because
engine will be hot enough to cause a burn.
17. Refuel only when engine is cool.
18. If mower must be lifted to be transported, turn
off engine and stay behind the handle until all
moving parts stop.
Maintenance
1. Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or if assistance is desired, contact
your local Authorized Toro Service Dealer.
2. Before mower is cleaned, inspected, serviced, or
adjusted, stop engine and disconnect wire from
spark plug. Keep wire away from plug to prevent
accidental starting.
3. To ensure the mower is in safe operating
condition, frequently check and keep all nuts,
bolts, and screws tight. Ensure blade bolt is
tightened to 50 ft.-lbs. (68 N m).
EN–4
4. When servicing blade, refer to blade
maintenance section for correct installation and
servicing procedures.
5. To reduce fire hazard, keep engine free of
excessive grease, grass, leaves, and
accumulations of dirt.
6. Do not overspeed the engine by changing
governor settings.
7. Check grass catcher bag frequently for wear or
deterioration. Replace with a new bag when
worn or damaged for your protection.
8. Allow engine to cool before storing mower in
any enclosure. Do not store mower near any
open flame or where gasoline fumes may be
ignited by a spark.
9. At the time of manufacture, the mower
conformed to the safety standards in effect for
rotary mowers. To ensure best performance and
continued safety certification of the mower, use
genuine TORO replacement parts and
accessories. Replacement parts and accessories
made by other manufacturers may result in
nonconformance with the safety standards, and
that could be dangerous.