Remote Controller - Airwell FAV012 Manual De Instrucciones

Parts and Functions

Remote controller

28
29
30
31
32
33
34
35
1
TEMP
ON
2
OFF
SWING
3
MODE SLEEP
4
HEALTH FRESH
5
CLOCK SET
6
TIMER HIGH/SO
7
FILTER HEAT
8
LIGHT LOCK
RESET CODE
9
10
1.TEMP Setting Button
Used to set temperature.
The temperature ranges: 16 C~ 30 C.
In Up/Down function of filter, for controlling up
and down filter.
2.SWING Button
If you press this button once, auto swing will be activated.
If you press this button again, the louver will fix in the
present position.
3.Power ON/OFF Button
Used for unit to start or stop.
After power on, the LCD of remote controller will display
the previous operation state (except for TIMER,SLEEP
and SWING state).
4.Operation MODE Button
Used to select operation mode.
Every time you press MODE button, operation mode
changes according to following sequence:
Code A:
AUTO
COOL
27
26
25
24
23
22
21
20
19
18
FAN
17
16
15
14
13
36
12
11
FAN
DRY HEAT
5.HEALTH Button
Used to set health operation function.
6.CLOCK Button
Used to set correct time.
7.TIMER Button
Used to select TIMER mode:TIMER ON,TIMER
OFF, TIMER ON-OFF.
(Note: if the time of TIMER ON is the same as
TIMER OFF, TIMER ON-OFF cannot be set)
8. FILTER Button
Used to set up/down function of filter.
9.CODE Button
Used to select Code A or B, Normally at Code A.
As you cann't controll the indoor unit, please
change the Code to B.
10.RESET Button
Press this button by using a sharp article to resume
the correct operation of the remote controller in
case of need, for example, in case of malfunctions
due to electromagnetic disturbance.
11.LIGHT Button
Used to light the control panel
12.LOCK Button
Used to lock operation button and LCD display
contents. If you press this button, the other buttons
come out of function and lock state display appears;
if you press it again, lock state will be no more
active and lock state display will disappear.
13.HOUR Adjustment Button
Used to set clock and timer setting
14.HIGH/SO Button
Used to select HIGH or SOFT operation.
15.SET Button
Used to confirm TIMER and CLOCK settings.
16.FRESH Button
Used to set fresh mode, the unit will draw in fresh
air.
17.SLEEP Button
Used to set sleep mode. (The clock must be
corrected before setting sleep function)
18.FAN Button
Used to select fan speed:LOW,MID,HIGH,AUTO.
19.TIME Display
20.TIMER Display
21.FILTER Display
When the filter need be cleaned, you can press
the FILTER button for 3s, to up/down function.
22.TEMPERATURE Display
23.AUTO SWING Display
5