Airwell FAV012 Manual De Instrucciones página 18

Operation instruction
ON/OFF operation
MODE FAN
OPERATION
HIGH
COOL
ROOM TEMP.
CLOCK
Note
Several seconds after the operation of the line controller, the setting of the unit will change.
Remarks
Avoid pressing "ON/OFF" switch frequently.
Do not press line controller or switches by sharp objects.
The temperature is on the basis of the setting value. The wind temperature may not reach the
setting value because of the outer air conditioner and system protection.
When the wired controller is power on, the screen fully displays it for two seconds. and clock
zone "8888"-"888"-"88"-"8" flicker for 30 seconds. All the switches are invalid at the time.
MODE FAN SWING
HEALTH TEMP
CLOCK TIME
TIMER SET RECOVERY
CHECK FILTER
RESET
ON/OFF
Press ON/OFF switch on line controller
2
directly
4
The line controller displays the running state
in the latest time (timing and swing state
5
may not be displayed).
1. Press "ON/OFF" switch.
3
The air conditioner starts operating, and the
light on the wired controller is on.
2.Choose operation mode.
Press "mode"switch to change to
"AUTO"---"FAN ONLY"---"COOL"---"DRY"---
"HEAT".
1
3.Press "TEMP" switch
6
Change set temperature:press TEMP
TEMP every time, [SET] will display, and
set temperature will increase/reduce 1*
4.Press "FAN SPEED" switch
FAN ONLY Operation:
Press "FAN SPEED" switch to change to
"HIGH"--"MED"--"LOW"--"HIGH"
In AUTO,COOL,DRY,HEAT Operation:
Press "FAN SPEED" switch to change to
"AUTO"--"HIGH"--"MED"--"LOW"--"AUTO"
5.Press "SWING" switch on the line
controller to swing the wind screen.
6.Press "ON/OFF"switch, off.
The light on the line controller is off.
10
or