Getting Started; Accessories; Set The Voltage Selector Switch; How To Put Batteries In The Remote Control - JVC MX-KC50 Manual De Instrucciones

Getting Started

Accessories

Make sure that you have all of the following items, which are supplied with the System.
AM Loop Antenna (1)
FM Wire Antenna (1)
Remote Control (1)
Batteries (2)
AC Plug Adaptor (1)
If any of these items are missing, contact your dealer immediately.

Set the VOLTAGE SELECTOR Switch

To avoid damaging the System, set the voltage before plugging in the System.
Set the correct voltage for you area with the VOLTAGE SELECTOR switch on the back of the Unit. Use a screwdriver to slide the selector up and
down.
CAUTION:
• Make all connections before plugging the System into an AC power outlet.

How To Put Batteries In the Remote Control

Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment.
CAUTION:
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
❏ To avoid battery leakage or explosion:
• Remove batteries when the Remote Control will not be used for a long time.
• When you need to replace the batteries, replace both batteries at the same time with new ones.
• Do not use an old battery with a new one.
• Do not use different types of batteries together.
3
R6P(SUM-3)/AA(15F)