Getting Started; Unpacking; Putting The Batteries Into The Remote Control; Connecting The System Control Cables And The External Wire - JVC UX-G66 Manual De Instrucciones

Getting Started

Unpacking

After unpacking, check to be sure that you have all the
following items.
The number in the parentheses indicates the quantity of the
pieces supplied.
• AM loop antenna (1)
• FM antenna (1)
• Remote control (1)
• Batteries (2)
• Speaker cords (2)
• External wire (1)
If any is missing, consult your dealer immediately.
Putting the Batteries into the Remote
Control
Insert the batteries — R6P (SUM-3)/AA (15F) — into the
remote control, by matching the polarity (+ and –) on the
batteries with the + and – markings on the battery
compartment.
When the remote control can no longer operate the units,
replace both batteries at the same time.
1
3
• DO NOT use an old battery together with a new
one.
• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, it will be damaged from battery
leakage.
R6P(SUM-3)/AA(15F)
2
Connecting the System Control Cables and
the External Wire
UX-G66 micro component system consists of three units,
AX-UXG66 Stereo Amplifier, XT-UXG66 Compact
Disc/Tuner, TD-UXG66 Cassette Deck, and SP-UXG66
Speaker System.
You can easily connect these units using the system control
cables equipped on the rear panel of the units.
• To prevent malfunction, connect the external wire as
illustrated.
External wire
(supplied)
1
FROM CONNECTOR-B
2
3
DO NOT change vertical stacking order of the
units as illustrated to avoid heat buildup.
• To connect the cables, press the middle of the connector
body until it clicks into the connector on the rear panel.
• To disconnect, if needed, pull the connector out pushing
both sides of the connector body. Never pull out the cables
themselves.
To connect
When connecting the system control cables to
the connectors
Make sure to connect the cable to the connector
having the same name such as "FROM
CONNECTOR-A" and "TO CONNECTOR-A."
AX-UXG66
VOLTAGE SELECTOR
FROM CONNECTOR-A
XT-UXG66
TO CONNECTOR-A
TD-UXG66
TO CONNECTOR-B
To disconnect
6