Getting Started - JVC UX-V10 Manual De Instrucciones

Getting Started

Accessories
Make sure that you have all of the following items, which are supplied with the System.
AC Power Cord (1)
AM Loop Antenna (1)
Remote Control (1)
Batteries (2)
FM Wire Antenna (1)
AC Plug Adaptor (except for Hong Kong and Argentina) (1)
If any of these items are missing, contact your dealer immediately.
Setting the VOLTAGE SELECTOR Switch
To avoid damaging the System, set the voltage before plugging in the system.
Set the correct voltage for your area with the VOLTAGE SELECTOR switch on the back of the Unit. Use a screwdriver to rotate the selector
so that the voltage number the arrow is pointed at is the same as the voltage in your area.
VOLTAGE SELECTOR
230V
127V
How to Put Batteries in the Remote Control
Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment.
CAUTION: Handle batteries properly.
To avoid battery leakage or explosion:
• Remove batteries when the Remote Control will not be used for a long time.
• When you need to replace the batteries, replace both batteries at the same time with new ones.
• Do not use an old battery with a new one.
• Do not use different types of batteries together.
Using the Remote Control
The Remote Control makes it easy to use many of the functions of the System from a distance of up to 7 m away.
You need to point the Remote Control at the remote sensor on the System's front panel.
2
EN01-09.UX-V10[U]
110V
R6(SUM-3)/AA(15F)
2
AUTO T APE SELECTOR
AUTO REVERSE
DIGITAL AUDIO
VERTICAL DISC
LOADING MECHANISM
MICRO COMPONENT SYSTEM
STANDBY
AUX
REC
REV.
MODE
Remote sensor
TAPE
PHONES
DOWN MULTI CONTROL
00.4.19, 10:45 AM
T APE
COMPACT
UX-V10
AHB
PRO
VOLUME
TIMER
CLOCK
CD
OPEN/CLOSE
FM/AM CD
UP