Handheld; Configuration; Battery Type And Replacement - Dal Zotto INSERTO IDRO 800 Manual Del Usuario

HANDHELD

CONFIGURATION

HANDHELD CODING PROCEDURE:
1. Disconnect the power supply to the stove.
OK
2. Press keys and
OK
3. Using keys and
4. Power the stove. Con rm the selected unit within 10 seconds (all LEDs ash on the radio/emergency card) by pressing the OK key on
the handheld.
5. All LEDs on the radio/emergency card will remain on for 2 seconds to con rm the new con guration.
6. If the con guration was unsuccessful, the display will read "
OK
THE HANDHELD IS ALREADY CONFIGURED WITH "UNIT 0", IN THE EVENT THERE IS ANOTHER STOVE. TO AVOID
INTERFERENCES, A NEW CONFIGURATION MUST BE PERFORMED, MODIFYING ONE OF THE TWO STOVES.
SOME RADIO FREQUENCY DEVICES E.G. MOBILE PHONES, ETC... MAY CAUSE INTERFERENCE WITH
COMMUNICATION BETWEEN THE HANDHELD AND THE STOVE.

BATTERY TYPE AND REPLACEMENT

To insert/replace the batteries, su ce it to remove the battery protection cover at the back of the handheld ( gure 1).
Insert the batteries in accordance with the symbols imprinted on the handheld and on the battery itself.
Three AAA batteries are required for the handheld to function.
Respect the environment!
Used batteries contain metals that are harmful to the environment, and therefore must be disposed of separately in
special containers.
60
at the same time until the UNIT selection screen appears.
select the new UNIT.
( gure 1)
". In this case, repeat the procedure.
ENGLISH