Commissioning Settings; Date And Time; Language; Set Degrees - Dal Zotto INSERTO IDRO 800 Manual Del Usuario

COMMISSIONING SETTINGS

Once the supply cable has been connected to the back of the generator, and after the insert has been locked with the latch, proceed with the
con guration.
LINE FREQUENCY 50/ 60HZ
If the generator is installed in a country with a frequency of 60Hz, the generator will display "incorrect line frequency". In this case, adjust the
frequency to 60Hz.

DATE AND TIME

This menu allows the date and time to be set.
To set: OK > SETTINGS > DATE /TIME.

LANGUAGE

This menu allows the preferred language to be selected.
To set: OK > SETTINGS > LANGUAGE.

SET DEGREES

This menu allows to set the desired unit of measurement.
To set: OK > SETTINGS >SET DEGREES
DO NOT USE ANY TYPE OF FLAMMABLE LIQUIDS FOR IGNITION!
DO NOT ALLOW THE BAG OF PELLETS TO COME INTO CONTACT WITH THE BOILING HOT STOVE DURING THE
FILLING PHASE!
IN THE EVENT OF CONTINUED FAILURE TO LIGHT, CONTACT AN AUTHORISED TECHNICIAN.
NO IGNITION
THE APPLIANCE MAY FAIL TO LIGHT BECAUSE THE AUGER IS EMPTY AND NOT ALWAYS ABLE TO LOAD THE BURN POT
WITH THE NECESSARY QUANTITY OF PELLETS IN TIME TO REGULARLY IGNITE THE FLAME.
IF THE PROBLEM OCCURS AFTER ONLY A FEW MONTHS OF OPERATION, CHECK THAT THE ROUTINE CLEANING
DESCRIBED IN THE STOVE BOOKLET HAS BEEN CARRIED OUT CORRECTLY.
IT IS FORBIDDEN TO USE THE DEVICE WITHOUT THE PELLET CHUTE/
SEPARATOR A AND FLAME GUARD B .
THEIR REMOVAL WILL COMPROMISE THE SAFETY OF THE PRODUCT AND
IMMEDIATELY VOID THE WARRANTY.
IN THE EVENT OF WEAR OR DETERIORATION, REQUEST THE REPLACEMENT
OF THE PART FROM THE AFTER SALES SERVICE.
REPLACEMENT NOT COVERED BY THE WARRANTY OF THE PRODUCT OR
BECAUSE COMPONENT SUBJECT TO WEAR .
64 ENGLISH
A
B