Parameter Setting And Display - Sime GO 18 BF(G20) Manual De Uso

EN
7.3

Parameter setting and display

m
CAUTION
Displaying and setting the parameters can ONLY be
carried out by the authorised technical support centre
or by professionally qualified personnel.
To go into the parameter menu:
– remove the two screws (1), pull the front panel (2) forwards
and release it from the top by lifting it
2
– turn dial t to 6
OFF
RESET
– press > and <
at the same time
screen displays "tS0.1" (index number of 1st parameter)
1
Fig. 49
Fig. 50
for at least 5 seconds until the
– press button > , for at least 1 second, to scroll up the list of
parameters, or button < , for at least 1 second, to scroll down
the list
– once the required parameter has been reached, press buttons
> and < for 1 second to confirm and thereby access the set
value which will flash on the display and can then be modified
– to modify the value, within the permitted range, hold down,
for at least 1 second, button
reduce it
– once the required value has been reached, press buttons
and < at the same time for 1 second to confirm and go back to
the list of parameters
– continue with modifying any other parameters.
When all the parameter modifications have been made, exit the
parameter menu by pressing
least 5 seconds until the initial screen is displayed, or wait 5
minutes to automatically exit the menu.
> to increase it or button <
> and < for at
at the same time
to
>
71