Tabla de contenido
Publicidad
Figure 8
Figure 9
Figure 10
Page
-30-
3
/
"
minimum
16
How To Prepare the Machine For
Operation
How To Install the Squeegee
To install the squeegee onto the machine, follow this
procedure:
1.
The squeegee assembly has a break away feature
that is also used for mounting the squeegee. Loosen
the knobs on the squeegee (figure 8). Slide the stud
into the slotted hole in the support frame on the
machine.
2.
Attach the vacuum hose cuff to the squeegee hose
fitting (see figure 9).
3.
Tighten knobs. NOTE: Do not overtighten or break
away feature is lost and damage may occur.
NOTE: To prevent damage to the squeegee or machine, the
squeegee was designed to break away from the machine.
If the squeegee is impacted and it breaks away from the
machine, simply reinstall it by following step 1-3.
How to Adjust the Squeegee
During operation, the rear squeegee blade should have a
constant 3/16" minimum flare along the entire squeegee
blade (see figure 10).
1.
The squeegee body can be tilted to adjust the
squeegee blade flare in the middle to match the flare
on the ends. To adjust the tilt, loosen the adjusting
bolt located on the left and right side of the squeegee
(see figure 9).
2.
Press down on the squeegee until both sets of guide
wheels contact floor.
3.
After making adjustments, retighten the screw(s).
NOTE: It is important that the right and left wheels are
contacting the floor in order for the squeegee to work.
NOTE: As the rear squeegee blade wears, it can be rotated
and/or flipped to obtain four good edges before having to
change blades.
®
Clarke
Operator's Manual -Focus Rider Scrubber
EN
Publicidad
Tabla de contenido
