Tabla de contenido
Publicidad
Figure 23
Page
-42-
How To Operate the Machine
How to Fill the Solution Tank
The solution tank fill port is located at the left side of the
machine (see figure 23). To fill the solution tank, follow
this procedure:
1. Turn the key switch to the "OFF" position.
2. Remove lid.
3. Add a cleaning chemical to the solution tank. For
the correct amount of chemical, follow the directions
shown on the container. NOTE: Excess foam in
the recovery tank could damage the vacuum
motor, so use only the minimum amount of
detergent necessary.
WARNING:
Always use low foam detergent.
To avoid the production of foam,
before starting to clean, put a
minimum quantity of antifoam
liquid into the recovery tank.
NEVER USE PURE ACID.
4. Fill the solution tank with clean water (see figure 22).
5. After filling the solution tank, replace the solution
tank lid.
WARNING:
Water solutions or cleaning
materials used with this type of
machine can leave wet areas on
the floor surface. These areas
can cause a dangerous condition
for the operator or other persons.
Always put CAUTION signs near
the area you are cleaning.
WARNING:
Machines can ignite flammable
materials and vapors. Do not use
with or near flammables such as
gasoline, grain dust, solvents and
thinners. Only use a cleaning
concentration recommended by
the chemical manufacturer.
WARNING:
Clarke recommends a maximum
water temperature of 120°F
(49°C).
Operating the Machine
NOTE: Before scrubbing with the machine, become
familiar with the operations and handling of the machine.
Run the machine at the lowest traverse speed. Use the
machine in an area that has no furniture or objects until
you can do the following:
1. Traverse the machine in a straight direction, forward
and backward.
2. Stop the machine safely.
3. Turn the machine both left and right and return to a
straight direction.
o
4. Turn a 180
turn where one rear wheel just pivots.
®
Clarke
Operator's Manual -Focus Rider Scrubber
EN
Publicidad
Tabla de contenido
