Parallel Screen - Tripp-Lite SmartOnline SUT20K Manual Del Propietário

8. LCD Display and Settings
7. Control & Test
Route: Main Screen  Setting Menu  CONTROL & TEST
FORCE BYPASS TRANSFER: Enables or disables the Force Bypass Transfer. The default setting is YES.
AUTO RESTART: Enables or disables Auto Restart. If set to ON, the UPS will shut down and automatically restart. The default setting is ON.
Use function keys ( ), (
8. Parallel Setup
Route: Main Screen  Setting Menu  PARALLEL SETUP
PARALLEL ID: Every parallel UPS system's PARALLEL ID should be different. When UPS systems are in a parallel configuration, you can
change the PARALLEL ID to avoid ID confict. There are four settings: 01, 02, 03 and 04.
Use function keys ( ), (
9. Advanced
Route: Main Screen  Setting Menu  ADVANCED
CLEAR STATISTICS: Includes RUN TIME, ON BAT COUNTS, ON BYPASS COUNTS, and TOTAL EVENT COUNTS. You can clear statistics of
all the above items.
FIRMWARE UPGRADE: This option upgrades the firmware. Firmware upgrades must be performed by qualified personnel only. There are
two choices to upgrade: PFC and SYSTEM
Use function keys ( ), (

8.3 Parallel Screen

When UPS systems are paralleled, press either the function key (
Screen:
• ID: In parallel mode, this is the UPS ID number.
• MID: Master UPS ID number. (In parallel mode, there is only one master UPS).
• INV: " " means "CONNECTED".
• ON: " " means "INVERTER ON".
) and ( ) to change the CONTROL & TEST setting.
) and ( ) could change the setting of PARALLEL ID.
) and ( ) to change the ADVANCED setting.
ID
MID
INV
ON
) or ( ) in a Main Screen to enter into the Parallel
1 2 3 4
36