Stihl MM 55 Manual De Instrucciones página 6

English
exposure to vibration are mentioned as
factors in the development of whitefinger
disease. In order to reduce the risk of
whitefinger disease and carpal tunnel
syndrome, please note the following:
Wear gloves and keep your hands
–
warm.
A power tool with loose components
–
will tend to have higher vibration
levels.
Maintain a firm grip at all times, but
–
do not squeeze the handles with
constant, excessive pressure. Take
frequent breaks.
All the above-mentioned precautions do
not guarantee that you will not sustain
whitefinger disease or carpal tunnel
syndrome. Therefore, continual and
regular users should closely monitor the
condition of their hands and fingers. If
any of the above symptoms appear,
seek medical advice immediately.
Warning!
The ignition system of the STIHL unit
produces an electromagnetic field of a
very low intensity. This field may inter-
fere with some pacemakers. To reduce
the risk of serious or fatal injury, persons
with a pacemaker should consult their
physician and the pacemaker manufac-
turer before operating this tool.
Proper Clothing
Warning!
To reduce the risk of injury, the operator
should wear proper protective apparel.
4
Warning!
Never operate your
power tool unless wear-
ing goggles or properly
fitted protective glasses
with adequate top and
side protection complying
with ANSI Z 87.1 (or your applicable
national standard). To reduce the risk of
injury to your face STIHL recommends
that you also wear a face shield or face
screen over your goggles or protective
glasses.
Power tool noise may damage your
hearing. Wear sound barriers (ear plugs
or ear mufflers) to protect your hearing.
Continual and regular users should
have their hearing checked regularly.
Be particularly alert and cautious when
wearing hearing protection because
your ability to hear warnings (shouts,
alarms, etc.) is restricted.
Good footing is very
important. Wear sturdy
boots with nonslip soles.
For further instructions on proper
clothing see the safety precautions in
the instruction manual of the MultiTool
you are using.
THE POWER TOOL
For illustrations and definitions of the
power tool parts see the chapter on
"Main Parts."
Warning!
Never modify this power tool in any way.
Only attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL MultiEngine
model are authorized. Although certain
unauthorized attachments are useable
with STIHL power tools, their use may,
in fact, be extremely dangerous.
If this tool is subjected to unusually high
loads for which it was not designed (e.g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the fuel system is tight (no leaks) and
that the controls and safety devices are
working properly. Do not continue
operating this machine if it is damaged.
In case of doubt, have it checked by your
STIHL servicing dealer.
THE USE OF THE POWER TOOL
Transporting the Power Tool
Warning!
Always switch off the engine and make
sure the working tool has stopped
before putting a power tool down. When
transporting your power tool in a vehi-
cle, properly secure it to prevent
turnover, fuel spillage and damage to
the power tool.
Fuel
Your STIHL power tool uses an oil-
gasoline mixture for fuel (see the
chapter on "Fuel" of your instruction
manual).
MM 55, MM 55 C