Thermador PROFESSIONAL SERIE Operating And Installation Manual página 12

8. On the wood bracket, mark the locations used to hang
the hood according to Figure 10.
Wood
Bracket
Screws 2 ea
1½" (38)
A
HOOD SIZE
30'' (762 mm) 13'' (330 mm)
36'' (914 mm) 16'' (406 mm)
42'' (1067 mm) 19'' (483 mm)
48'' (1219 mm) 22'' (559 mm)
54'' (1372 mm) 25'' (635 mm)
9. Drill a 3/16'' (4.8 mm) tap hole through the wooden
bracket and wall. These 5/8'' (16 mm) screws do not
need to go into the studs.
10. Use (2) 5/8'' (16 mm) screws to secure the wood
¼
bracket leaving '' (6 mm) of each screw exposed for
hanging the hood.
Discharge Direction: Horizontal discharge requires a wall
cutout, as shown in Figure 11, to provide clearance for the
transition. The location of the cutout is determined by the
hood installation height.
Dry Wall
12½"
(318 mm)
2¾" (69 mm)
Cooktop Centerline
English 10
2" (51)
A
A
Figure 10: Hanging the Hood
23" (584 mm)
Base of Hood
Location
Figure 11: Cutout Dimensions
Note: Dashed line indicates cutout needed for clearance of
the transition.
The transition supplied with the hood connects to standard
10-inch round duct. Figure 12 shows the transition
connected for horizontal discharge.
Figure 12: Transition Centerline for Horizontal Discharge
Figure 13 shows the hood configured for vertical discharge.
Installations using this method require a cutout in the
ceiling to accommodate 10'' (254 mm) duct and the ½''
(13 mm) conduit carrying power to the unit.
Transition
Centerline
Figure 13: Transition Centerline for Vertical Discharge
Duct covers, sold separately, are available to cover the
space between the top of the hood and ceiling (see
Figure 16).
10¼"
(260 mm)
Transition
Centerline
10½"
(267 mm)
13
"
/
5
16
(148 mm)
W
A
L
L
10¼" 10¼" 10¼"
(260 mm) (260 mm) (260 mm)
18"
(457 mm)