Transporting Machine; Storing Machine; Freeze Protection; Fastt System Freeze Protection - Tennant 5400 Manual Del Operador

TRANSPORTING MACHINE

When transporting machine by use of trailer or truck,
be certain to follow tie–down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Raise squeegee and scrub head.
2. Load machine using a recommended loading
ramp.
3. Position front of machine up against front of trailer
or truck. Once machine is positioned, lower scrub
head and squeegee.
4. Set parking brake, if equipped, and place a block
behind each drive wheel to prevent machine from
rolling.
5. Secure machine using tie-down brackets located
at rear of machine frame, if equipped. It may be
necessary to install tie-down brackets to the floor
of your trailer or truck.
6. Place tie–down straps over top of machine to
prevent it from tipping.
NOTE: Do not use control grips to secure machine for
transporting.
FOR SAFETY: When transporting machine, use a
recommended ramp when loading/unloading
into/off truck or trailer, use tie–down straps to
secure machine to truck or trailer.

STORING MACHINE

1. Charge batteries before storing. Never store
machine with discharged batteries.
2. Drain and rinse tanks thoroughly.
3. Store machine in a dry area with squeegee and
scrub head in the raised position.
4. Remove recovery tank lid to promote air
circulation.
ATTENTION: Do not expose machine to rain; store
indoors.
Tennant 5400 (05–03)
Home Find... Go To..

FREEZE PROTECTION

1. Be sure the solution tank and recovery tank are
empty.
2. Pour 3.8 L of pre–mixed automotive–type
windshield washer solution into the solution tank.
3. Turn the machine power on.
4. Start the solution flow.
5. The washer solution does not need to be drained
from the solution tank.

FaSTt SYSTEM FREEZE PROTECTION

FaSTt Winterizing Kit #613898 is required.
1. Disconnect the FaSTtPAK from the system and
connect the quick–disconnect fitting, supplied with
kit, to the inlet line of the concentrate pump.
2. Using a small cup, drain as much of the FaSTt
concentrate from the inlet line as possible (Figure
72). If the concentrate does not flow out of the
line, simply squeeze and release the inlet hose
several times.
FIG. 72
OPERATION
27