Installing Fastt Pak Agent (Option) - Tennant 5400 Manual Del Operador

OPERATION
4. Align brush/pad driver under motor hub and push
driver upward to engage. Be certain that
brushes/pad drivers are secure before operating
machine (Figure 8).
FIG. 8
5. To remove brush/pad drivers: raise scrub head,
turn machine off, remove key and push brush
release knobs downward (Figure 9).
FIG. 9
(For Cylindrical Brush Scrub Head Model)
See REMOVING BRUSHES/PADS.

INSTALLING FaSTt PAK AGENT (OPTION)

Machine must be equipped with the FaSTt Option.
1. Remove the perforated knock-outs from the
FaSTt PAK 365 Floor Cleaning Concentrate
carton. Do not remove the bag from the carton.
Pull out the bag's hose connector at the bottom of
the bag and remove the orange hose cap from the
connector (Figure 10).
ATTENTION: The FaSTtPAK 365 Floor Cleaning
Concentrate is specifically designed for the
FaSTt system scrubbing application. NEVER use
a substitute, machine damage will result.
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
10
Home Find... Go To..
FIG. 10
2. Place the FaSTt PAK carton in the carton holder
at the rear of the machine and connect the supply
hose to the FaSTt PAK bag (Figure 11).
FIG. 11
NOTE: If any dried concentrate is visible on the
supply hose connector or on the FaSTt PAK
connector, soak and clean with warm water.
3. Make sure to connect the supply hose onto the
hose storing plug when not in use (Figure 12).
This will prevent the FaSTt solution system from
drying out and clogging up the supply hose.
FIG. 12
4. The FaSTt solution system MUST be primed for
first time use. To prime system, make sure the
solution tank is empty and operate the machine in
the FaSTt Scrub Mode for 3 minutes (See
MACHINE OPERATION). This step is only
required for first time FaSTt system use.
Tennant 5400 (05–03)