Emergency Stopping (Option); Operating Fastt Scrub System (Option) - Tennant 5400 Manual Del Operador

9. Turn solution flow knob to desired solution flow
rate (Figure 22).
NOTE: When scrubbing with the FaSTt Option, the
solution flow is pre-set by the FaSTt system.
FIG. 22
10. Observe brush pressure meter while operating.
Meter should read within the green zone, press
brush pressure switch to adjust (Figure 23).
ATTENTION: Do not operate machine with pad
pressure meter in red zone, circuit breakers will
trip and floor damage may occur.
FIG. 23
11. To operate machine in reverse, gradually rotate
control grips backwards.
12. To stop scrubbing, release control grips, raise
scrub head and squeegee.
13. After scrubbing, perform the Daily Maintenance
procedures (See MACHINE MAINTENANCE).
Tennant 5400 (05–03)
Home Find... Go To..

EMERGENCY STOPPING (OPTION)

In the event of an emergency while operating, strike
the power kill button at rear of control console to halt
machine. Turn button clockwise to reset (Figure 24).
FIG. 24

OPERATING FaSTt SCRUB SYSTEM (OPTION)

How the FaSTt System operates (Foam Scrubbing
Technology). The FaSTt PAK concentrate agent is
injected into the system with a mixture of a small
amount water and compressed air. This mixture creates
a large volume of expanded wet foam. The expanded
foam mixture is then dispersed onto the floor while two
scrubbing discs go to work. By the time the squeegee
picks up the mixture, the patented foaming agent has
collapsed and recovered into the recovery tank. By
performing the FaSTt system application, you can
increase your productivity rate by 30% by reducing your
dump/fill cycle. You will also reduce your chemical usage
and storage space. One FaSTt PAK of concentrated
agent allows you to scrub up to 1 million sq. ft.
1. Make sure that the FaSTt PAK 365 Floor
Cleaning Concentrate carton is properly installed
(See INSTALLING FaSTt PAK AGENT).
2. Make sure that the solution tank is filled with clear
cool water only. DO NOT add conventional
cleaning agents in solution tank. Conventional
cleaning agents/restorers in the solution tank will
result in premature FaSTt system failure.
OPERATION
13