Foppapedretti BIKINI plus Manual De Instrucciones página 16

GB
ASSEMBLY
Important note: the images and instructions contained in the booklet refer to one version of the
stroller; some components and functions described may vary depending on the version you have
purchased.
HOW TO OPEN THE STROLLER ( fig.1, fig.2)
Move the closing lever "a", as shown in the figure (fig.1).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked
(fig.2).
FITTING THE REAR WHEELS (fig.3,fig.4, fig.5, fig.6)
Place the rear wheel unit on the frame, until it is completely locked on. Ensure, from both sides of
the chassis, that the wheel unit is locked on correctly.
The wheel support is properly assembled when the metal pins lock in the holes on the frame pipes
(fig.4).
Fit the rear wheels on the axis in the direction shown by the arrow.
Press button "A" while pulling the wheel to remove it from the axis (fig.6).
ADJUSTING THE SHOCK ABSORBER, REAR WHEELS (fig.7)
For softer suspension, move lever "A" towards the back.
For harder suspension, move lever "A" towards the front.
Make sure that lever "A" is adjusted to the same position on both sides.
FITTING THE FRONT WHEELS (fig.8, fig.9, fig.10)
Place the wheel pin inside the bushing in the centre of the wheel support
Press button "A" down to disable the swivelling movement. Press button "A" again (button will pop
up) to activate the swivelling movement.
Press button "B" on the external side to remove the wheels
STROLLER CONFIGURATION
STROLLER VERSION SEAT (fig. 11, fig.12,fig.13,)
Make sure the automatic buttons or velcro ( depending on the version you have purchased) are
properly fastened, as shown in the figure. The fabric must envelop the metal bracket.
Fasten belt "A" and belt "B" on the lower part of the footrest.
To lift the backrest, hold adjuster strap "C" with one hand and, with the other, slide adjuster
device "D" towards the backrest.
To recline the backrest, press the button in the middle of adjuster device "D" and slide it
downward.
FITTING THE SEAT (fig.14, fig.15)
Line up the seat connectors with their adapters and press downwards. A click will indicate proper
16
BIKINI Plus