Foppapedretti BIKINI plus Manual De Instrucciones página 19

GB
Push the stroller forwards to direct the front wheels longitudinally.
Move button "A" to the right, as shown in the figure, while pressing button "B" at the same time.
Fold the handlebar downwards.
Bring the front wheel chassis towards the back.
Fold up the footrest.
Make sure it is closed properly.
OPENING THE STROLLER (from fig.43 to fig.48)
Place the stroller as shown in the figure.
Lift closing lever "A" (right side), as shown in the figure (fig.44), while lifting the handlebar upwards
until the stroller opens completely.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked
(fig.48).
USING THE CAR SEAT ACCESSORY
If you wish, you can use the BIKINI Plus car seat (Group 0+) with the stroller.
Closely follow the instructions below.
Remove the seat from the chassis, see the "Fitting the seat" paragraph.
USING THE CAR SEAT ACCESSORY (fig.49)
IMPORTANT: the car seat accessory must only be fitted to the chassis facing the parent.
Engage the stroller parking brake.
Remove the stroller seat.
Fitting the adapters (from fig. 50 to fig.53)
Insert the adapters on the car seat side, see fig.51, fig.52, fig.53.
Make sure the adapters are properly inserted and fastened to the car seat.
Removing the adapters (fig.54, fig.55)
To remove the adapters, press the red "A" button on the upper part of the car seat while removing
the adapter from it.
Fastening the car seat to the stroller chassis (fig. 56)
Position the car seat with the adapters inserted facing the parent and, after having lined up the
fastening systems, press downward until you hear a click, indicating proper fastening.
IMPORTANT: Make sure both sides are fastened correctly; the car seat must not detach from the
stroller chassis if lifted upwards.
Releasing the car seat from the stroller chassis (fig. 56 - fig. 57)
Put the car seat handle in the upright position, pressing the red buttons on the side. See the manual
19
BIKINI Plus