Shutting Down - Hofmann EEWB746A Manual Del Operador

35
F6
4-12
F6
4-11
Operation
5.2.3 Settings
After switching on the unit, a default weight mode is
shown. if the unit then shows another weight mode,
refer to Chapter 5.3 and 5.4.
The unit of measurement indicated at power up is
inches, but the setting selected before switching off
for grams / ounces remains.
5.2.3.1 Changing the Weight Unit
Default weight unit setting: grams.
Proceed as follows to change the weight unit, whether
you have already spun the wheel or not.
• Press the key "gr/Oz" (F6, Fig. 4-12).
Repeat the procedure to turn the display back to
grams.
5.2.3.2 Changing the Dimensions Unit
Default diameter and width unit setting: inches.
• Press the key "mm-inch" (F6, Fig. 4-11).
Repeat the procedure to turn the display back to
inches.

5.2.4 Shutting down

Always shut down properly when work is complete:
• Remove the and hub nut and the wheel from the
balancer.
• Remove the cones from the stub shaft. Check the
surfaces (internal and external) of the cones for
damage. The condition of the cone is very important
for a good balance quality.
• Store the cones and the hub nut in the correct
place.
• Check the thread of the hub nut and stub shaft.
• Clean all threads and surfaces with a dry, soft
cloth.
• unplug the mains cable from the power outlet.
• Check the power cable for damage or wear.
• Tidy up the storage areas.
• Clean the display and input panel with a soft, dry
cloth.
• Remove old wheel weights and other material from
under the balancer. The balancer must rest on its
three feet only.
Operator's Manual EEWB746A