Hofmann EEWB746A Manual Del Operador página 55

55
5-21
5-22
5-23
5-24
Operation
5.8.1 Alu 2P and Alu 3P (HWM) weight
modes:
Refer to Figure 5.21.
The gauge arm must be used to apply the stick-on
weight(s).
 index the wheel to the exact position for correction
in the right correction plane.
When the position is reached, two green arrows
appear.
 Press the pedal of the main shaft lock to hold the
wheel in this position.
Decide to use Hidden Weight Mode «HWM» now
(Chapter 5.9).
 Clean the fitting position before attaching the
adhesive weights.
 insert at the centre of the gauge arm an adhesive
weight that complies with the imbalance measured
and remove the protective tape from the adhesive
strip (a, Figure 5-22).
Note: When the value "0" appears while moving
the arm, the machine beeps to indicate
that the correct application position has
been reached.
• Apply the weight to the correct point on the rim.
• Rotate the wheel to the next WAP position, put
the stick-on weight on the gauge arm and apply
the weight at the left plane reference point (Fig.
5-23).
 After applying the balance weights perform a Test
Run.
Operator's Manual EEWB746A