Description Of The Equipment - Cebora WIN TIG DC 220 M Manual De Instrucciones

E
D
F
3 INSTALLATION
Make sure that the supply voltage matches the voltage in-
dicated on the specifications plate of the welding machine.
When mounting a plug, make sure it has an adequate ca-
pacity, and that the yellow/green conductor of the power
supply cable is connected to the earth pin.
The capacity of the overload cutout switch or fuses installed
in series with the power supply must be equivalent to the
absorbed current I1 of the machine.
.
3.1 ASSEMBLY
Only skilled personnel should install the machine. All con-
nections must be carried out according to current regula-
tions, and in full observance of safety laws (CEI 26-36 E and
IEC/EN 60974-9).

3.2 DESCRIPTION OF THE EQUIPMENT

A – DISPLAY SCREEN.
B - ENCODER KNOB
Various tasks are conducted with encoder knob B:
1) adjusting a parameter
Turn the encoder knob.
2) selecting a parameter or activating a section.
20
A
B
C
H
Rapidly press and release the encoder knob.
3) Returning to main screen
hold down for more than 0.7 seconds and
release the knob when the main screen is dis
played
C - POSITIVE OUTPUT TERMINAL (+)
D – NEGATIVE OUTPUT TERMINAL (-)
E – FITTING
(1/4 GAS) Used to connect TIG welding torch gas hose
F - 10-PIN CONNECTOR
The following remote controls must be connected to this
connector:
a) pedal
b) welding torch with start button
c) welding torch with potentiometer
d) welding torch with up/down etc...
From pin 3 to pin 6, the "ARC ON" function is available
G – SWITCH
Starts and stops the machine
H – GAS INPUT FITTING
G