Babyauto ST-4 iSIZE Manual De Uso página 13

IMPORTANT
Please read carefully BEFORE installing
the child seat in the vehicle.
NOTIFICATION
1. The correct fitting of 3-point belt or the ISOFIX anchoring systems is of
vital importance for the safety of your child.
2. This car seat is designed to offer the optimal safety in all installation
modes described in this manual.
3. This is a i-Size booster seat Enhanced Child Restraint System. It is
approved according to Regulation No. 129, for use primarily in " i-Size
seating positions" as indicated by vehicle manufacturers in the vehicle
user's manual. If in doubt, consult either the Enhanced Child Restraint
System manufacturer or the retailer.
4. A correct fit is likely if the vehicle manufacturer has declared in the
vehicle handbook that the vehicle is capable of accepting an " i-Size
Universal" child restraint system for this age group.
5. Ensure that the part of any abdominal belt or strap should rest as low as
possible over the child's hips, on both sides.
6. Please read the instructions carefully, as incorrect installation could
result in serious injury. If any injuries should occur as a result of incorrect
installation, the manufacturer will accept no liability.
7. The product has been approved according to the strictest European
safety standards (ECE R129) and is suitable for the height range between
100 and 150 cm.
8. Please never use the safety seat without its cover or without the harness
protectors.
9. Fastening a child dressed in outerwear could reduce the efficiency of the
restraint system.
10. Make sure to protect the child safety seat from direct sunlight as it could
heat up and hurt the child.
11. Child seats or harness accessories that are damaged or have been used
incorrectly must be replaced.
12. Do not leave heavy objects inside the car, as these may injure the child in
the event of an accident.
13. Make sure that the buckle is correctly fastened so that the child can be
quickly freed in case of emergency.
14. The safety seat's rigid and plastic elements should be positioned and
13