Tractel tracpode Manual De Empleo Y De Mantenimiento página 16

Wingnut
GB
Cable idler pulley
Cable securing pin in working position
1 - Fit the Blocfor mounting bracket on one of the Tracpode legs
and check that the tracpode is equipped with a pulley kit:
three possible positions.
2 - Lock the bracket with the mounting pin and the safety pin.
3 - Remove the locking nut from the mounting lug.
4 - Run the Blocfor cable through the slot in the mounting bracket.
5 - Install the Blocfor on the threaded part of the mounting lug
then tighten the locking nut.
6 - If the Blocfor moves, adjust the position of the mounting brac-
ket, then lock it in position with the wing nut.
7 - Pull out the cable securing pin to run the Blocfor cable through
the pulley then through the inside of the Tracpode head.
8 - Reinstall the pin to lock the system.
Installing the CAROL mounting bracket :
Fit bracket on leg
16
Locking nut
Mounting lug
Cable securing pin
Lock bracket with pin and safety pin
Install cable Secure cable with cable
securing pin
1 - Fit the Carol mounting bracket on one of the Tracpode legs
and check that the Tracpode is equipped with a pulley kit: 3
possible positions.
2 - Lock the bracket using the locking pin and the safety pin.
3 - Secure the unit on the bracket with 4 screws M10 for the 20
m version, or 4 screws M12 for the 30 m version
4 - Pull out the cable securing pin to run the Carol cable through
the pulley then through the inside of the Tracpode head.
5 - Reinstall the pin to lock the system.
Installing a fall-arrester on the Tracpode head:
Temporary anchor point complying with requirements of
standard EN 795 B.
The Tracpode head is equipped with 3 anchor points and has
been tested to secure a fall by two users. As a safety precaution,
we recommend that you do not connect the two fall-arrest sys-
tems to the same anchor point.
When using rope suspension work systems, you must use a
separate personnel suspension anchor and fall-arrest anchor.
Insofar as possible, the anchor point should be located at a
height of between 1.5 and 2 meters above the user's feet.
A connector EN 362 must be used for the anchor point connec-
tion.
For connection of the fall-arrest system to the fall-arrest harness,
refer to the manual for the PPE used.
CAUTION
Before and during use, it is necessary to plan out how possible
rescue can be efficiently and safely conducted, within less than
15 minutes. Beyond such time, the person's life is in danger.
Anchor point
Connector