Permanently Store Additional Weight (Pt); Activate Autohold Function (Ahold) - Seca 954 Manual De Usuario

Permanently store
additional weight (Pt)
Activate Autohold
function (Ahold)
70 •
You can use the Pre-Tare function to permanently store
an additional weight and automatically deduct it from
the measured result. You can for example store a flat-
rate figure as the weight of shoes and clothing and then
always deduct it from the measured result when a
patient is weighed fully dressed.
1. Select the item "Pt" in the menu.
The message "Pt" appears.
2. Confirm your selection.
Arrows can be seen flashing in the display.
The additional weight last stored is displayed.
3. You can accept the stored value or adjust it using
the arrow keys.
NOTE:
If you enter the value "0", the function will be
switched off. The message "Pt" will no longer
be displayed.
4. Confirm your selection.
5. Ask the patient to sit down on the scale.
The patient's weight is displayed.
The additional weight stored has been
automatically deducted.
6. To disable this function, select the item "Pt" in the
menu again.
7. Confirm your selection.
The function is disabled.
You will leave the menu automatically.
NOTE:
When you switch the scale off, the function is
switched off. The message "Pt" is no longer dis-
played when you switch the scale on again.
If you activate the Autohold function, the measured
result for each weighing operation will continue to be
displayed after the load has been removed. This means
you no longer have to manually activate the Hold func-
tion for every weighing operation.
NOTE:
With certain models this function is already
activated at the factory. If required, you can
disable this function.