Using The Quick Hitch - Burley TRAVOY Manual De Instrucciones Y Seguridad Del Propietario

Using the Quick Hitch

Attaching to Bike:
1. Unlatch the hitch by rotating the handle away from the
hitch (Figure 10), then unhook the T-bolt from the mating
slot.
2. Place the hitch body against the seat post and then wrap
the rest of the hitch around the seat post (Figure 11).
3. Position the T-bolt into the mating slot (Figure 12).
4. Fold the lever in towards the hitch body (Figure 13).
5. Adjust tension as needed to ensure a secure fit.
NOTE: When properly adjusted the lever will leave a
clear imprint on the palm of your hand. If you have any
questions about using your Quick Hitch, please consult
your Burley dealer.
Adjusting to Different Seat Post Sizes:
1. Rotate the T-bolt to adjust the hitch to fit different seat
post diameters:
a. Rotate clockwise to adjust to a smaller diameter
seatpost (Figure 14).
b. Rotate counter-clockwise to adjust to a larger diameter
seatpost (Figure 15).
Removing From Bike:
1. Unlatch the quick hitch by rotating the handle away from
the hitch, then unhook the T-bolt from the mating slot.
2. Remove from seat post.
NOTES:
1. Hitch is compatible with 25-35mm seat posts.
2. Use of hitch with carbon fiber seat posts or dropper-posts
is not recommended.
3. Hitch is only compatible with circular seat posts.
4. At least 40mm of the seat post surface must be
accessible to attach the hitch.
5. If your legs rub on the sides of hitch, lowering it can help.
6
ENG
Figure 10
Figure 12
Figure 14
Figure 11
Figure 13
Figure 15
TRAVOY