Mettler Toledo IND560 Guia De Instalacion página 8

IF THE KEYBOARD, DISPLAY LENS OR ENCLOSURE IS DAMAGED ON A
DIVISION 2 APPROVED OR CATEGORY 3 MARKED IND560 PANEL-
MOUNT OR HARSH TERMINAL THAT IS USED IN A DIVISION 2 OR ZONE
2/22 AREA, THE DEFECTIVE COMPONENT MUST BE REPAIRED
IMMEDIATELY. REMOVE AC POWER IMMEDIATELY AND DO NOT REAPPLY
AC POWER UNTIL THE DISPLAY LENS, KEYBOARD OR ENCLOSURE HAS
BEEN REPAIRED OR REPLACED BY QUALIFIED SERVICE PERSONNEL.
FAILURE TO DO SO COULD RESULT IN BODILY HARM AND/OR PROPERTY
DAMAGE.
NOT ALL VERSIONS OF THE IND560 ARE DESIGNED FOR USE IN
HAZARDOUS (EXPLOSIVE) AREAS. REFER TO THE DATA PLATE OF THE
IND560 TO DETERMINE IF A SPECIFIC TERMINAL IS APPROVED FOR USE
IN AN AREA CLASSIFIED AS HAZARDOUS BECAUSE OF COMBUSTIBLE OR
EXPLOSIVE ATMOSPHERES.
WHEN THIS EQUIPMENT IS INCLUDED AS A COMPONENT PART OF A
SYSTEM, THE RESULTING DESIGN MUST BE REVIEWED BY QUALIFIED
PERSONNEL WHO ARE FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF ALL COMPONENTS IN THE SYSTEM AND THE POTENTIAL
HAZARDS INVOLVED. FAILURE TO OBSERVE THIS PRECAUTION COULD
RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
TO AVOID DAMAGE TO THE PCB OR LOAD CELL, REMOVE POWER FROM THE IND560
TERMINAL AND WAIT AT LEAST 30 SECONDS BEFORE CONNECTING OR DISCONNECTING
ANY HARNESS.
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2,
GROUPS A, B, C, AND D; CLASS II GROUPS F AND G; CLASS III;
HAZARDOUS LOCATIONS OR NON-HAZARDOUS LOCATIONS ONLY.
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON THIS
EQUIPMENT BEFORE POWER HAS BEEN SWITCHED OFF OR THE AREA
HAS BEEN SECURED AS NON-HAZARDOU BY PERSONNEL AUTHORIZED
TO DO SO BY THE RESPONSIBLE PERSON ON-SITE.
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!