Pcb Jumper Positions; Main Pcb Jumper - Mettler Toledo IND560 Guia De Instalacion

IND560 Installation Manual

PCB Jumper Positions

Only the analog version of the Main board has a jumper on it. This section
provides the details for this jumper.

Main PCB Jumper

The IDNet version of the IND560 main board has no jumpers. There is one jumper
on the IND560 analog scale main board (W1). This jumper selects either 2 mV/V
or 3 mV/V operation of the analog circuitry. 3mV/V is the factory default position.
Refer to Figure 2-53 for the jumper location, and Figure 2-54 and Figure 2-55 for
its positions.
Figure 2-53: W1 Millivolt Jumper Location, Main PCB Uncovered
Figure 2-54: W1 Millivolt Jumper Location, Main PCB Cover Installed
2-33