Ethernet/Ip And Modbus Tcp Interface - Mettler Toledo IND560 Guia De Instalacion

Figure 2-45: PROFIBUS Option Board, Panel Mount Enclosure
Pin assignments for the PROFIBUS interface are shown in Figure 2-46.
Figure 2-46: PROFIBUS Nine-Pin Connector Assignments
Follow the wiring instructions included with the connector to terminate the wires.

EtherNet/IP and Modbus TCP Interface

The EtherNet/IP Module (Figure 2-47) connects to the network via a standard
Ethernet patch cable. The module's address is set in software, and the DIP
switches are not used and must all be set to OFF.
Figure 2-47: Ethernet / IP Option Board
Figure 2-48 shows the array of status indicator LEDs on the EtherNet/IP card.
NOTES:
PIN SIGNAL
1. USE MATING CONNECTORS AND CABLE
1 Not used
RECOMMENDED FOR PROFIBUS CONNECTIONS.
2 Not used
2. REFER TO PROFIBUS INTERNATIONAL
DOCUMENTATION FOR OTHER CONSIDERATIONS.
3 RxD/TxD +
4 RTS
5 GND bus
6 +5V bus
7 Not used
8 RxD/TxD -
9 Not used
IND560 Installation Manual
2-29