Starting The Pressure Washer - Westinghouse Annovi Reverberi WP2700 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2
Figure 22 – Water Connection – WP3000
1 - Water Inlet
Screen
NOTICE
Make sure water inlet screen is in place before
attaching hose.
3. Use the shortest hose possible to complete the
job at hand. Using a longer hose may affect
performace. Connect a garden hose that is not
longer than 50 feet (15.2 m) to the water inlet fi tting
(see Figure 21 and Figure 22).
4. Tighten the fi tting onto the hose.
5. Turn the water on and inspect for leaks.
6. Squeeze the trigger on the gun and allow any air to
bleed out of the hoses and the pump before starting
the engine.
7. Connect the soap hose to the soap bottle if using
soap.
1
2 - Water Inlet
Fitting
OPERATION
STARTING THE PRESSURE
WASHER
Before starting the pressure washer,
review Safety on page 7.
N
OTE:
Pressure washer may walk or move when used
on hard surfaces. Be sure the unit is secure
during operation.
Before attempting to start the pressure washer, verify
the following:
The engine is fi lled with engine oil (see Checking
Engine Oil on page 31).
The pressure washer is situated in a proper location
(see Location Selection on page 21).
DANGER
Never operate the pressure washer
in an enclosed area. Engine exhaust
contains carbon monoxide that can kill
in minutes. Only operate the pressure
washer outside and away from
windows, doors and vents.
1. Flip the trigger lock lever up and lock the trigger in
the OFF position (see Figure 23).
Figure 23 – Trigger Lock Lever
2. Make sure the water supply is turned on.
23

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Annovi reverberi wp3000

Tabla de contenido