Stopping The Pressure Washer; Normal Operation - Westinghouse Annovi Reverberi WP2700 Manual Del Propietário

6. WP3000 – Move the throttle lever to the full throttle
position (see Figure 28). Move the choke lever to
the choke position. Open the fuel shutoff valve.
1
2
Figure 28 – Throttle Lever, Choke Lever, Fuel Shutoff
1 - Throttle Lever
2 - Choke Lever
7. Firmly grasp and pull the starter handle slowly until
you feel increased resistance. At this point, apply a
rapid pull on the starter handle.
N OTE: If the engine starts briefl y and then shuts off,
squeeze the trigger on the spray gun to relieve
the pressure before trying to start the engine
again.
8. Once the engine starts, move the choke lever to the
open position. Allow the engine to warm up slightly
before beginning washing.
N OTE: WP3000 – Always operate the engine at full
throttle position when washing.
3
4
Valve
3 - Fuel Shutoff
Valve
4 - Starter Handle
OPERATION
STOPPING THE PRESSURE
WASHER

Normal Operation

During normal operation, use the following steps to stop
your pressure washer:
1. Lock the spray gun trigger lock in the OFF position.
2. Move the engine ON/OFF switch to the OFF (O)
position (see Figure 29 and Figure 30).
Figure 29 – Engine ON/OFF Switch OFF Position –
WP2700
Figure 30 – Engine ON/OFF Switch OFF Position –
WP3000
25