Playback Menus - JVC GR-D370U Manual De Instrucciones

MENUS FOR DETAILED ADJUSTMENT
32
EN
DEMO MODE
OFF: Automatic demonstration will not take
place.
[ON]: Demonstrates certain functions such as
Wipe/Fader and Effects, etc., and can be used
to confirm how these functions operate.
Demonstration starts in the following cases:
●
When the Menu Screen is closed after "DEMO
MODE" is turned "ON".
●
With "DEMO MODE" set to "ON", if there is no
operation for about 3 minutes after the Power
Switch is set to "REC".
●
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume.
NOTES:
●
If a cassette is in the camcorder, the
demonstration cannot be turned on.
●
"DEMO MODE" remains "ON" even if the
camcorder power is turned off.
[ ] = Factory-preset
QUALITY
[FINE] / STANDARD
The Picture Quality mode can be selected to
best match your needs. Two Picture Quality
modes are available: FINE (
STANDARD ( ) (in order of quality).
NOTE:
The number of storable images depends on the
selected picture quality as well as the composition
of the subjects in the images and the type of
memory card being used. (
REC SELECT
[ (TAPE)]: When Snapshot recording is
performed with the VIDEO/MEMORY Switch set
to "VIDEO", still images are recorded only onto
the tape.
/ (TAPE/CARD): When Snapshot
recording is performed with the VIDEO/
MEMORY Switch set to "VIDEO", still images
are recorded not only onto the tape but also in
the memory card (640 x 480 pixels).
DSC
) and
pg. 24)

Playback Menus

[ ] = Factory-preset
SOUND MODE and NARRATION
During tape playback, the camcorder detects the
sound mode in which the recording was made,
and plays the sound back. Select the type of
sound to accompany your playback picture.
According to the menu access explanation on
page 29, select "SOUND MODE" or
"NARRATION" from the Menu Screen and set it
to the desired parameter.
The setting below are effective only for video
playback except "BRIGHT" and "REC MODE".
The parameters (except "OFF" in ON SCREEN,
SOUND MODE and NARRATION settings) are
the same as in the description on page 30.
REC MODE
Allows you to set the video recording mode (SP
or LP) depending on your preference.
It is recommended you use "REC MODE" in
Playback Menu, when using this camcorder as a
recorder during dubbing.
* SP indicator does not appear on the sreen.
SOUND MODE
[STEREO ]: Sound is output on both "L" and
"R" channels in stereo.
SOUND L : Sound from the "L" channel is
output.
SOUND R : Sound from the "R" channel is
output.
NARRATION
Although it is not possible to perform audio
dubbing with this camcorder, you can hear
sound from as audio-dubbed tape during
playback using this function.
[OFF]: Original sound is output on both "L" and
"R" channels in stereo.
ON: Dubbed sound is output on both "L" and "R"
channels in stereo. (
MIX: Original and dubbed sounds are combined
and output in stereo on both "L" and "R" channels.
BRIGHT
pg. 17, "Brightness Adjustment Of The
Display"
DATE/TIME
[OFF]: The DATE/TIME does not appear.
ON: The DATE/TIME is always displayed.
ON SCREEN
When set to "OFF", the camcorder's display
disappears.
TIME CODE
pg. 20, "Time Code"
[SP]* / LP
pg. 45)
OFF / [LCD] / LCD/TV
[OFF] / ON