Brother P-Touch 2600 Guía De Usuario página 123

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Error Message
CAN'T
HERE!
CASSETTE
CHANGED!
CHANGE
ADAPTOR!
CUTTER
ERROR!
EEPROM
ERROR!
FEED
ERROR!
INPUT
WHOLE CODE
116
Cause
This message appears if the cursor is
at the end of the text when you hold
down c and press O.
This message appears if the tape cas-
sette is changed while the P-touch is
receiving data from the computer.
This message appears if a high-volt-
age adapter is being used.
This message appears if the tape cut-
ter is closed when you try to print or
feed the tape.
This message appears if a checksum
error occurred when the P-touch was
turned on or if the keyword was dam-
aged and failed to initialize.
This message appears if the AV label
sensor cannot detect the labels.
This message appears if the set
number of digits is not entered in the
barcode data.
Remedy
Move the cursor below a
number before holding down
c and pressing O.
Cancel the print job, install the
correct tape cassette, and then
try printing again.
Remove the high-voltage
adapter and connect the adapter
designed exclusively for this
machine.
Turn the P-touch off, then on
again.
Contact your service representa-
tive.
• Replace the AV label cassette
with one that is not empty.
• If this error message appears
even after a new AV label cas-
sette is installed, the sensor
may be damaged. Contact
your service representative.
Input the correct number of dig-
its or change the number of dig-
its set in the barcode parameters.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

P-touch 2610

Tabla de contenido