Greasing The Gas Tap - Angelo Po 1G1FAPG Manual De Uso

ADJUSTING TOP BURNER PRIMARY AIR
To carry out this operation, proceed as follows.
1-Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).

GREASING THE GAS TAP

To carry out this operation, proceed as follows.
1-Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
B
C
A
B
A
4 - Undo the screw (D) and lift the b urner support
(E) as far as it will go.
5 - Tighten the scre w (D) and restore the initial
conditions when the operation is complete.
E
7 - Coat the con e with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone
grease.
9 - Replace the cone (F) and the cap (E).
10-Replace the control panel (C) and the knobs
(A) on completion of the operation.
E
C
D
- 23 -
D
IDM-39618501500.tif
(F) to r emove the excess
F
IDM-39618301500.tif
IT
GB
DE
FR
ES
English